Filtered by vendor Linux
Subscriptions
Total
17893 CVE
| CVE | Vendors | Products | Updated | CVSS v3.1 |
|---|---|---|---|---|
| CVE-2025-68373 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 5.5 Medium |
| In the Linux kernel, the following vulnerability has been resolved: md: avoid repeated calls to del_gendisk There is a uaf problem which is found by case 23rdev-lifetime: Oops: general protection fault, probably for non-canonical address 0xdead000000000122 RIP: 0010:bdi_unregister+0x4b/0x170 Call Trace: <TASK> __del_gendisk+0x356/0x3e0 mddev_unlock+0x351/0x360 rdev_attr_store+0x217/0x280 kernfs_fop_write_iter+0x14a/0x210 vfs_write+0x29e/0x550 ksys_write+0x74/0xf0 do_syscall_64+0xbb/0x380 entry_SYSCALL_64_after_hwframe+0x77/0x7f RIP: 0033:0x7ff5250a177e The sequence is: 1. rdev remove path gets reconfig_mutex 2. rdev remove path release reconfig_mutex in mddev_unlock 3. md stop calls do_md_stop and sets MD_DELETED 4. rdev remove path calls del_gendisk because MD_DELETED is set 5. md stop path release reconfig_mutex and calls del_gendisk again So there is a race condition we should resolve. This patch adds a flag MD_DO_DELETE to avoid the race condition. | ||||
| CVE-2025-68376 | 1 Linux | 1 Linux Kernel | 2026-04-15 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: coresight: ETR: Fix ETR buffer use-after-free issue When ETR is enabled as CS_MODE_SYSFS, if the buffer size is changed and enabled again, currently sysfs_buf will point to the newly allocated memory(buf_new) and free the old memory(buf_old). But the etr_buf that is being used by the ETR remains pointed to buf_old, not updated to buf_new. In this case, it will result in a memory use-after-free issue. Fix this by checking ETR's mode before updating and releasing buf_old, if the mode is CS_MODE_SYSFS, then skip updating and releasing it. | ||||
| CVE-2025-40035 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 5.5 Medium |
| In the Linux kernel, the following vulnerability has been resolved: Input: uinput - zero-initialize uinput_ff_upload_compat to avoid info leak Struct ff_effect_compat is embedded twice inside uinput_ff_upload_compat, contains internal padding. In particular, there is a hole after struct ff_replay to satisfy alignment requirements for the following union member. Without clearing the structure, copy_to_user() may leak stack data to userspace. Initialize ff_up_compat to zero before filling valid fields. | ||||
| CVE-2025-40051 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 7.0 High |
| In the Linux kernel, the following vulnerability has been resolved: vhost: vringh: Modify the return value check The return value of copy_from_iter and copy_to_iter can't be negative, check whether the copied lengths are equal. | ||||
| CVE-2025-40053 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 7.0 High |
| In the Linux kernel, the following vulnerability has been resolved: net: dlink: handle copy_thresh allocation failure The driver did not handle failure of `netdev_alloc_skb_ip_align()`. If the allocation failed, dereferencing `skb->protocol` could lead to a NULL pointer dereference. This patch tries to allocate `skb`. If the allocation fails, it falls back to the normal path. Tested-on: D-Link DGE-550T Rev-A3 | ||||
| CVE-2025-40057 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 5.5 Medium |
| In the Linux kernel, the following vulnerability has been resolved: ptp: Add a upper bound on max_vclocks syzbot reported WARNING in max_vclocks_store. This occurs when the argument max is too large for kcalloc to handle. Extend the guard to guard against values that are too large for kcalloc | ||||
| CVE-2025-68344 | 1 Linux | 1 Linux Kernel | 2026-04-15 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: ALSA: wavefront: Fix integer overflow in sample size validation The wavefront_send_sample() function has an integer overflow issue when validating sample size. The header->size field is u32 but gets cast to int for comparison with dev->freemem Fix by using unsigned comparison to avoid integer overflow. | ||||
| CVE-2025-68342 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 7.0 High |
| In the Linux kernel, the following vulnerability has been resolved: can: gs_usb: gs_usb_receive_bulk_callback(): check actual_length before accessing data The URB received in gs_usb_receive_bulk_callback() contains a struct gs_host_frame. The length of the data after the header depends on the gs_host_frame hf::flags and the active device features (e.g. time stamping). Introduce a new function gs_usb_get_minimum_length() and check that we have at least received the required amount of data before accessing it. Only copy the data to that skb that has actually been received. [mkl: rename gs_usb_get_minimum_length() -> +gs_usb_get_minimum_rx_length()] | ||||
| CVE-2025-40021 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 5.5 Medium |
| In the Linux kernel, the following vulnerability has been resolved: tracing: dynevent: Add a missing lockdown check on dynevent Since dynamic_events interface on tracefs is compatible with kprobe_events and uprobe_events, it should also check the lockdown status and reject if it is set. | ||||
| CVE-2025-68338 | 1 Linux | 1 Linux Kernel | 2026-04-15 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: net: dsa: microchip: Don't free uninitialized ksz_irq If something goes wrong at setup, ksz_irq_free() can be called on uninitialized ksz_irq (for example when ksz_ptp_irq_setup() fails). It leads to freeing uninitialized IRQ numbers and/or domains. Use dsa_switch_for_each_user_port_continue_reverse() in the error path to iterate only over the fully initialized ports. | ||||
| CVE-2025-39978 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 7.0 High |
| In the Linux kernel, the following vulnerability has been resolved: octeontx2-pf: Fix potential use after free in otx2_tc_add_flow() This code calls kfree_rcu(new_node, rcu) and then dereferences "new_node" and then dereferences it on the next line. Two lines later, we take a mutex so I don't think this is an RCU safe region. Re-order it to do the dereferences before queuing up the free. | ||||
| CVE-2025-39972 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 7.0 High |
| In the Linux kernel, the following vulnerability has been resolved: i40e: fix idx validation in i40e_validate_queue_map Ensure idx is within range of active/initialized TCs when iterating over vf->ch[idx] in i40e_validate_queue_map(). | ||||
| CVE-2025-68328 | 1 Linux | 1 Linux Kernel | 2026-04-15 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: firmware: stratix10-svc: fix bug in saving controller data Fix the incorrect usage of platform_set_drvdata and dev_set_drvdata. They both are of the same data and overrides each other. This resulted in the rmmod of the svc driver to fail and throw a kernel panic for kthread_stop and fifo free. | ||||
| CVE-2025-39969 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 7.0 High |
| In the Linux kernel, the following vulnerability has been resolved: i40e: fix validation of VF state in get resources VF state I40E_VF_STATE_ACTIVE is not the only state in which VF is actually active so it should not be used to determine if a VF is allowed to obtain resources. Use I40E_VF_STATE_RESOURCES_LOADED that is set only in i40e_vc_get_vf_resources_msg() and cleared during reset. | ||||
| CVE-2025-68318 | 1 Linux | 1 Linux Kernel | 2026-04-15 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: clk: thead: th1520-ap: set all AXI clocks to CLK_IS_CRITICAL The AXI crossbar of TH1520 has no proper timeout handling, which means gating AXI clocks can easily lead to bus timeout and thus system hang. Set all AXI clock gates to CLK_IS_CRITICAL. All these clock gates are ungated by default on system reset. In addition, convert all current CLK_IGNORE_UNUSED usage to CLK_IS_CRITICAL to prevent unwanted clock gating. | ||||
| CVE-2025-68316 | 1 Linux | 1 Linux Kernel | 2026-04-15 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: scsi: ufs: core: Fix invalid probe error return value After DME Link Startup, the error return value is set to the MIPI UniPro GenericErrorCode which can be 0 (SUCCESS) or 1 (FAILURE). Upon failure during driver probe, the error code 1 is propagated back to the driver probe function which must return a negative value to indicate an error, but 1 is not negative, so the probe is considered to be successful even though it failed. Subsequently, removing the driver results in an oops because it is not in a valid state. This happens because none of the callers of ufshcd_init() expect a non-negative error code. Fix the return value and documentation to match actual usage. | ||||
| CVE-2025-68307 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 7.0 High |
| In the Linux kernel, the following vulnerability has been resolved: can: gs_usb: gs_usb_xmit_callback(): fix handling of failed transmitted URBs The driver lacks the cleanup of failed transfers of URBs. This reduces the number of available URBs per error by 1. This leads to reduced performance and ultimately to a complete stop of the transmission. If the sending of a bulk URB fails do proper cleanup: - increase netdev stats - mark the echo_sbk as free - free the driver's context and do accounting - wake the send queue | ||||
| CVE-2025-68296 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 5.5 Medium |
| In the Linux kernel, the following vulnerability has been resolved: drm, fbcon, vga_switcheroo: Avoid race condition in fbcon setup Protect vga_switcheroo_client_fb_set() with console lock. Avoids OOB access in fbcon_remap_all(). Without holding the console lock the call races with switching outputs. VGA switcheroo calls fbcon_remap_all() when switching clients. The fbcon function uses struct fb_info.node, which is set by register_framebuffer(). As the fb-helper code currently sets up VGA switcheroo before registering the framebuffer, the value of node is -1 and therefore not a legal value. For example, fbcon uses the value within set_con2fb_map() [1] as an index into an array. Moving vga_switcheroo_client_fb_set() after register_framebuffer() can result in VGA switching that does not switch fbcon correctly. Therefore move vga_switcheroo_client_fb_set() under fbcon_fb_registered(), which already holds the console lock. Fbdev calls fbcon_fb_registered() from within register_framebuffer(). Serializes the helper with VGA switcheroo's call to fbcon_remap_all(). Although vga_switcheroo_client_fb_set() takes an instance of struct fb_info as parameter, it really only needs the contained fbcon state. Moving the call to fbcon initialization is therefore cleaner than before. Only amdgpu, i915, nouveau and radeon support vga_switcheroo. For all other drivers, this change does nothing. | ||||
| CVE-2025-68226 | 1 Linux | 1 Linux Kernel | 2026-04-15 | 5.5 Medium |
| In the Linux kernel, the following vulnerability has been resolved: smb: client: fix incomplete backport in cfids_invalidation_worker() The previous commit bdb596ceb4b7 ("smb: client: fix potential UAF in smb2_close_cached_fid()") was an incomplete backport and missed one kref_put() call in cfids_invalidation_worker() that should have been converted to close_cached_dir(). | ||||
| CVE-2025-68238 | 1 Linux | 1 Linux Kernel | 2026-04-15 | N/A |
| In the Linux kernel, the following vulnerability has been resolved: mtd: rawnand: cadence: fix DMA device NULL pointer dereference The DMA device pointer `dma_dev` was being dereferenced before ensuring that `cdns_ctrl->dmac` is properly initialized. Move the assignment of `dma_dev` after successfully acquiring the DMA channel to ensure the pointer is valid before use. | ||||